Company News
CURRENT:HOME > NEWS > Company News
Briefly introduce: What are the operating specifications of environmental protection automatic sandblasting machine?
[2026-11-04]

Briefly introduce: What are the operating specifications of environmental protection automatic sandblasting machine?


Environmental protection automatic sandblasting machine is characterized by its own closed cabin and supporting dust removal and recovery system. It is widely used in matte, deburring and pretreatment of workpiece surface. Standardized operation can not only stabilize product quality, but also control dust overflow and meet environmental protection requirements. The main operating specifications are as follows.

Before starting the machine, operators need to be trained before taking up their posts, and wear labor protection articles such as dust mask, goggles, wear-resistant gloves, protective clothing and earplugs as required. First clean up the sundries around the equipment, and check whether the door seal, safety interlock and emergency stop switch are normal; Check that there is no air leakage in the compressed air pipeline, the air source pressure is stable and the oil-water separator is normal; Check that the dust removal unit, filter element and abrasive recovery mechanism are intact and unobstructed, and the abrasive is dry without caking and impurities, and the material is supplemented as needed; Fixtures and fixtures shall be installed firmly, and the workpieces to be shielded shall be protected in advance, and the grounding line shall be confirmed to be intact without potential safety hazards. After the preparation is completed, follow the sequence of starting the dust removal system first, then feeding the air source, and finally starting the automatic sand blasting program. After the parameter debugging is completed, the first piece shall be confirmed, and the appearance and roughness are up to standard before mass production.

During the automatic operation of the equipment, it is forbidden to open the hatch, remove the protective device, put your hand into the sandblasting chamber, and change the process parameters such as air pressure, spray gun speed and reciprocating stroke at will. Observe the running state of the equipment continuously, and pay attention to the phenomena such as sand leakage, abnormal sound, pressure fluctuation, and decreased dust removal suction. In case of nozzle blockage, pipeline jitter, dust overflow and other anomalies, immediately press the emergency stop, turn off the air supply, and then check and clean up after the equipment is completely stopped and the pressure is released. It is forbidden to carry out maintenance under pressure. In the process of automatic sand blasting, keep the dust removal system on all the way, and rely on the negative pressure in the cabin to control the dust not to be discharged, so as to ensure the environmental protection standard; Observe the stock of abrasives regularly, and replenish abrasives with the same specifications in time to avoid mixing affecting the appearance consistency.

When the machine is shut down after the operation, stop the sand blasting procedure first, and let the dust removal equipment run for a period of time after the spray gun and conveying mechanism are in place, so as to fully extract the suspended dust in the cabin, and then turn off the air source, dust removal unit and main power supply in turn. After taking out the workpiece, check the residual sand on the surface of the workpiece and do a good job of purging and cleaning. After each shift is completed, clean the inner wall of the cabin, recover the dust and waste accumulated in the screen, check the wear of nozzles and bushings, and record the equipment status in time.

Daily compliance with environmental and safety management requirements, no open fire in the operation area, away from flammable and explosive materials, and regular cleaning of dust accumulated in the dust collector to prevent dust risks. During the production of different workpieces, it is necessary to thoroughly clean the machine to prevent cross-contamination of abrasives with different particle sizes and types. Do not use the equipment for a long time, empty the sand bin, and do a good job in pipeline and filter element maintenance. Strictly following this set of specifications can reduce dust emission, stabilize sand blasting effect and reduce the probability of equipment failure and safety accidents.


【RETURN】