Kunshan Hua Guan Shen sandblasting introduction: Stainless steel sandblasting machine operation method?

1. Operation process before use. Connect to the air source and power supply of the sandblasting machine, and turn on the power switch on the electrical box. Adjust the pressure of compressed air entering the gun through the pressure reducing valve to between 0.4 and 0.6MPa as required. When selecting a suitable abrasive injector bin, be sure to add sand slowly to avoid clogging.

2. Operation process during use. To stop using the sandblasting machine, the power and air supply of the sandblasting machine must be cut off. Check whether there is any abnormality in each part, and check whether the pipe connection is strong regularly. Any items other than the specified abrasives shall not be dropped into the work compartment so as not to affect the circulation of abrasives. The surface of the workpiece to be machined must be dry.

3. The operation process after the use of the sandblasting machine equipment. When it is urgent to stop processing, press the emergency stop button switch, and the sandblasting machine will stop working. Cut off power and air to the machine. To stop the shift, first clean the workpiece, turn off the gun switch; Let it flow back into the separator. Turn off the dust removal unit. Turn off the power switch on the electrical box. Finally, it is discussed how to replace the abrasive of the sand blasting machine. Thoroughly clean the abrasive attached to the working table, the inner wall of the sand blasting gun and the mesh plate, and make it flow back to the separator. Open the bottom plug of the sand regulating valve and collect the abrasive into a container. Add new abrasive to the cabin as needed, but start the fan first.