We all know that saving abrasives of sandblasting machine (structure: feeding system, circulation system, etc.) is closely related to the success of production. To make the fastest efficiency and the lowest abrasive wear, it is necessary to know the data quality and specific accurate data of the user's products. Only when we know each other well, we can also make the best effect. Next, Kunshan huaguanshen sandblasting is about how to save abrasives from five aspects.

1. Rough edge embrittlement

The sandblasting machine is to use the low-temperature freezing effect of liquid nitrogen to make the rubber plastic alloy data embrittlement. At the moment, the burr is prior to the product and the product is not brittle. During the time difference between the raw edge embrittlement and the products without embrittlement, a kind of high molecular particle is ejected at high speed to impact the product burr to remove the burr of rubber plastic alloy products and aluminum and zinc alloy products with high quality.

2. Dust collector

Sandblasting machine (structure: feeding system, circulation system, etc.) before the application to the best position. Sand blasting machine is a kind of machine which uses compressed air as power to form high-speed jet beam to spray the spraying material to the surface of the workpiece to be processed, which changes the mechanical properties of the surface of the workpiece. The sandblasting machine completes the full active sandblasting through the electrical control system, and can actively adjust the sandblasting viewpoint, sandblasting time, sandblasting interval, back blowing time, the movement of the spray gun and the rotation speed of the worktable. Remove the filter cartridge of the dust collector (function: purify the air) on time, and dump the waste sand in time, so as to minimize the use of abrasive.

3. Spray gun

Before using the sandblasting machine (structure: feeding system, circulation system, etc.), it is necessary to check whether there is any wear (a basic type of parts failure) in the spray gun, and once the sand nozzle is inspected. Nozzle and other places have wear (a basic type of parts failure), to timely replace, indirectly avoid the destruction of abrasive.

4. Sand pipe

Whether the sand pipe is straight or not is a necessary work to be inspected before the sandblasting machine (structure: feeding system, circulation system, etc.) works. If it is folded, it will certainly spoil the amount of sanding.

5. Separator

It is the most important part of saving abrasives. Before you choose to buy sandblasting machine (structure: feeding system, circulation system, etc.), you'd better tell the manufacturer the type of abrasive before the process is determined. In this way, the sandblasting machine manufacturer can combine the specifications you need well in the design to achieve accurate control. The sandblasting machine is to use the low-temperature freezing effect of liquid nitrogen to make the rubber plastic alloy data embrittlement. At the moment, the burr is prior to the product and the product is not brittle. During the time difference between the raw edge embrittlement and the products without embrittlement, a kind of high molecular particle is ejected at high speed to impact the product burr to remove the burr of rubber plastic alloy products and aluminum and zinc alloy products with high quality. Abrasives will naturally help to reduce the use of measurement.